Connecting Audio - Honeywell HNVE1 Reference Manual

Encoder Installation
20
Table 2-2 HNVE1 Connectors
Connector Description
I-; I+ Alarm Input
O-; O+ Alarm Output
D-; D+ RS485 Connectors (for PTZ control)
Ethernet LAN Connector, RJ45
Power/+12V GND DC Power Connector
Note To ensure that good quality video signals are sent to the encoder, power off
the HNVE1, connect the video lines, then power on the encoder. Then enable
or disable video termination as required. See
Configuring Video
Connecting Video
Network RJ45 Ethernet Connection
The main video connection for your HNVE1 is made through your Ethernet network
connection. Connect the Ethernet connector on the rear of the HNVE1 to your network
using an Ethernet (10Base-T, 100Base-TX) cable.
Note You can connect your HNVE1 to a network or connect it directly to a PC or
laptop using a crossover cable.

Connecting Audio

The HNVE1 supports bi-directional audio. There are two supported voice band channels
that function in full duplex mode. The HNVE1 can transmit audio from the HNVE1 to the
client (PC) using any audio source that provides an industry standard line level input (3.5
mm jack). The HNVE1 can also receive audio from the client (PC) and provide an industry
standard line level output (3.5 mm jack) suitable to connect to audio devices. Audio input
and output have 600 Ohm impedance. See
configure audio options.
Settings.
Configuring Video Settings
Video Termination on page
on page 67 to
61 in