Preset Tours - Honeywell HNVE1 Reference Manual

Before You Begin Configuring

Preset Tours

52
In a preset tour, the PTZ dome moves from one preset to another. The PTZ dome remains
at each position for a specified amount of time (dwell time) before moving to the next preset
position. You can configure up to 16 preset tours. Each preset tour can consist of up to 64
presets. For details on configuring a preset tour, see
The time interval for which the PTZ dome stays at a preset is referred to as the dwell time.
The dwell time can range from 1 to 99 seconds. The speed at which the PTZ camera moves
from one preset to another preset is referred to as the velocity. The velocity can range from
o o
1 to 480 per second, depending on the capability of the camera model.
Note You can start a preset tour after configuring it. To start a preset tour, select the
preset tour under Preset Tour Details and then click
Starting a Preset Tour
1. Click the Live View tab.
Click Run in the PTZ Settings pane. The Run Cont. Preset Tour options appear.
2.
Type in the tour number in the field next to Run Cont. Preset Tour. If the tour
3.
number is less than 10, type 0 before the number. For example, for preset tour 9, type
09.
Enter
4. Click . The preset tour starts and the PTZ camera moves to the first preset in the
tour. The tour loops until you break the cycle.
Stopping A Preset Tour
You can stop a preset tour by:
• Using the PTZ Control
• Selecting another function (for example, start a Mimic Tour)
• Clicking Halt
Configuring a Preset Tour on page 65.
.