Encoder Installation
Mounting the HNVE1 Encoder
Choosing the Location
Mounting Considerations
Mounting in a Rack
24
Caution
Connect power either from a 12 VDC source or a CAT5 Ethernet
connector (PoE); never both at the same time.
Choose an installation location for the HNVE1 that:
•
Provides access to the correct and reliable power supply (see
and access to a video-in feed
•
Protects the encoder from dust, dirt, and liquids
•
Allows air to flow around the vents
•
Conforms with local regulatory guidelines
Avoid any installation environment where the HNVE1 is:
•
Exposed to strong vibrations or uneven surfaces
•
Exposed to direct sunlight or is near a heat source such as a radiator
•
Exposed to high humidity or where condensation forms easily
•
Near high-voltage cables such as a power cable
•
Exposed to dust and dirt
•
Exposed to extreme fluctuations in temperature
Do not block ventilation openings in the cover.
Install the HNVE1 in the rack as low as possible.
Securely mount the HNVE1 in a 19 in. EIA standard rack.
To mount the HNVE1 in the rack:
1.
Attach the mounting brackets (supplied) to the sides of the HNVE1 using the supplied
screws.
Electrical
on page 81)