Figure 9-7 Provisioning An Ethernet Circuit; Figure 9-8 Choosing A Circuit Source - Cisco 15454-TCC - Network Processor Card Operation Manual

Ethernet Circuit Configurations
Navigate to the other ONS 15454 Ethernet circuit endpoint.
Step 5
Step 6 Repeat Steps 2 – 5.
Step 7 Click the Circuits tab and click Create.
The Circuit Creation (Circuit Attributes) dialog box opens
Figure 9-7
In the Name field, type a name for the circuit.
Step 8
From the Type pull-down menu, choose STS.
Step 9
The VT and VT Tunnel types do not apply to Ethernet circuits.
Step 10
Choose the size of the circuit from the Size pull-down menu.
Step 11
The valid circuit sizes for an Ethernet Multicard circuit are STS-1, STS-3c and STS6c.
The valid circuit sizes for an Ethernet Single-card circuit are STS-1, STS-3c, STS6c and STS12c.
Step 12 Verify that the Bidirectional checkbox is checked and click Next.
The Circuit Creation (Circuit Source) dialog box opens
Figure 9-8
Choose the circuit source from the Node menu. Either end node can be the circuit source.
Step 13
Cisco ONS 15454 Installation and Operations Guide
9-8
Provisioning an Ethernet circuit
Choosing a circuit source
Chapter 9
(Figure 9-7).
(Figure 9-8).
Ethernet Operation
November 2001