Power And Ground Installation; Figure 1-21 Installing The Fan-Tray Assembly - Cisco 15454-TCC - Network Processor Card Operation Manual

Power and Ground Installation

Figure 1-21 Installing the fan-tray assembly

1.8 Power and Ground Installation
This section explains how to connect the ONS 15454 assembly to the power supply. Ground the
equipment according to Telcordia standards or local practices.
Warning Shut off the power from the power source or turn off the breakers before beginning work.
This equipment is intended to be grounded. Ensure that the host is connected to earth ground
Warning
during normal use.
Caution Always use the supplied ESD wristband when working with a powered ONS 15454. Plug the
wristband cable into the ESD jack located on the lower-right outside edge of the shelf assembly.
Warning Do not mix conductors of dissimilar metals in a terminal or splicing connector where physical
contact occurs (such as copper and aluminum, or copper and copper-clad aluminum), unless the
device is suited for the purpose and conditions of use.
Cisco ONS 15454 Installation and Operations Guide
1-28
FA N
FA IL
C R
IT
M A
J
M IN
Fan tray
assembly
Chapter 1 Hardware Installation
November 2001