Chapter 7
Card Provisioning
Table 7-7
Heading
Send Do Not
Use
PJ Sts Mon #
Status
Type
Step 4
Click Apply.
Procedure: Provision Threshold Settings for OC-N Cards
Step 1
Display the OC-N card in CTC card view
Step 2
Click the Provisioning > Thresholds tabs.
Figure 7-2
Modify the settings shown in
Step 3
Default thresholds apply to all optical cards unless otherwise specified.
November 2001
OC-N Card Line Settings on the Provisioning > Line Tab (continued)
Description
When checked, sends a DUS (do not use) message on
the S1 byte
Sets the STS that will be used for pointer
justification. If set to 0, no STS is monitored. Only
one STS can be monitored on each OC-N port. See
the
"Pointer Justification Count Parameters" section
on page 8-12
for more information.
Places port in or out of service
Defines the port as SONET or SDH. See the
"Provisioning OC-N Cards for SDH" section on
page
7-23.
Provisioning thresholds for the OC48 IR 1310 card
Table 7-8 on page
(Figure 7-2 on page
7-19).
7-20.
Cisco ONS 15454 Installation and Operations Guide
Provisioning Optical Cards
Options
•
Yes (checked)
•
No (unchecked; default)
0 (default) - 3 (OC-3, per
•
port)
•
0 (default) - 12 (OC-12)
0 (default) - 48 (OC-48)
•
0 (default) - 192 (OC-192)
•
Out of Service (default
•
•
In Service
•
Sonet
•
SDH
7-19