Table of Contents
Advertisement
ONS 15454 IP Addressing Scenarios
Figure 4-6
Subnet Mask 255.255.255.0
Default Gateway = 192.168.1.1
IP Address 192.168.2.20
Subnet Mask 255.255.255.0
Procedure: Create a Static Route
Use the following steps to create a static route.
Step 1
Log into the ONS 15454 and select the Provisioning > Network tabs.
Step 2
Click the Static Routing tab. Click Create.
In the Create Static Route dialog box enter the following:
Step 3
•
Cisco ONS 15454 Installation and Operations Guide
4-8
Scenario 5: Static route with multiple LAN destinations
LAN D
Router #3
LAN C
LAN A
CTC Workstation
IP Address 192.168.1.100
Host Routes = N/A
ONS 15454 #2
Default Router = N/A
Static Routes = N/A
Destination—Enter the IP address of the computer running CTC. To limit access to one computer,
enter the full IP address (in the example, 192.168.1.100). To allow access to all computers on the
192.168.1.0 subnet, enter 192.168.1.0 and a subnet mask of 255.255.255.0. You can enter a
destination of 0.0.0.0 to allow access to all CTC computers that connect to the router.
Router #2
Router #1
IP Address of interface "A" to LAN "A" 192.168.1.1
IP Address of interface "B" to LAN "B" 192.168.2.1
Subnet Mask 255.255.255.0
Int "A"
Int "B"
ONS 15454 #1
IP Address 192.168.2.10
Subnet Mask 255.255.255.0
Default Router = 192.168.2.1
Static Routes
SONET RING
Chapter 4
Destination 0.0.0.0
Mask 0.0.0.0
Next Hop 192.168.2.1
Cost = 2
ONS 15454 #3
IP Address 192.168.2.30
Subnet Mask 255.255.255.0
Default Router = N/A
Static Routes = N/A
IP Networking
LAN B
November 2001
Advertisement
Table of Contents
