Cisco 15454-TCC - Network Processor Card Operation Manual page 18

Figures
Figure 5-21 A UPSR with a fiber break
Figure 5-22 An OC-3 UPSR
Figure 5-23 Layout of Node ID 0 in the OC-3 UPSR example (Figure 5-15)
Figure 5-24 Layout of Node IDs 1 - 3 in the OC-3 UPSR example (Figure 5-15)
Figure 5-25 Connecting fiber to a four-node UPSR
Figure 5-26 Using the span shortcut menu to display circuits
Figure 5-27 Switching UPSR circuits
Figure 5-28 An ONS 15454 with multiple subtending rings
Figure 5-29 A UPSR subtending from a BLSR
Figure 5-30 A BLSR subtending from a BLSR
Figure 5-31 Viewing subtending BLSRs on the network map
Figure 5-32 Configuring two BLSRs on the same node
Figure 5-33 A linear (point-to-point) ADM configuration
Figure 5-34 Verifying working slots in a protection group
Figure 5-35 Deleting a protection group
Figure 5-36 Converting a linear ADM to a UPSR
Figure 5-37 A UPSR displayed in network view
Figure 5-38 Converting a linear ADM to a BLSR
Figure 5-39 A path-protected mesh network
Figure 5-40 A PPMN virtual ring
Figure 6-1 Creating a circuit
Figure 6-2 Setting circuit routing preferences
Figure 6-3 Specifying circuit constraints
Figure 6-4 Creating a circuit
Figure 6-5 A VT1.5 monitor circuit received at an EC1-12 port
Figure 6-6 Editing UPSR selectors
Figure 6-7 Selecting the Edit Path Trace option
Figure 6-8 Setting up a path trace
Figure 6-9 Example #1: A VT1.5 circuit in a BLSR
Figure 6-10 Example #2: Two VT1.5 circuits in a BLSR
Figure 6-11 Example #3: VT1.5 circuit in a UPSR or 1+1 protection scheme
Figure 6-12 Example #4: Two VT1.5 circuits in UPSR or 1+1 protection scheme
Figure 6-13 A VT1.5 tunnel
Figure 6-14 A six-node ring with two VT1.5 tunnels
Figure 6-15 A DCC tunnel
Cisco ONS 15454 Installation and Operations Guide
xviii
5-27
5-28
5-31
5-34
5-37
5-39
5-44
5-45
5-47
5-48
5-51
5-52
6-3
6-4
6-5
6-6
6-11
6-14
6-14
6-17
6-19
6-20
6-22
5-29
5-29
5-33
5-37
5-40
5-41
5-41
5-43
6-9
6-17
6-18
6-18
November 2001