Figure 6-16 Selecting Dcc Tunnel End Points - Cisco 15454-TCC - Network Processor Card Operation Manual

Chapter 6 Circuits and Tunnels

Figure 6-16 Selecting DCC tunnel end points

Click OK.
Step 5
Put the ports hosting the DCC tunnel in service:
Step 6
Double-click the card hosting the DCC in the shelf graphic or right-click the card on the shelf
a.
graphic and select Open.
Click the Provisioning > Line tabs.
b.
Under Status, select In Service.
c.
d. Click Apply.
DCC provisioning is now complete for one node. Repeat these steps for all slots/ports that are part of
the DCC tunnel, including any intermediate nodes that will pass traffic from third party equipment. The
procedure is confirmed when the third-party network elements successfully communicate over the
newly-established DCC tunnel.
November 2001
Cisco ONS 15454 Installation and Operations Guide
Creating DCC Tunnels
6-23