Table of Contents
Advertisement
Connecting PCs to the ONS 15454
From the Internet Properties dialog box, click Connections > LAN Settings.
Step 3
Step 4
On the LAN Settings dialog box, either:
•
or
•
Procedure: Disable Proxy Service Using Netscape (Windows and Solaris)
Complete these steps if your computer is connected to a proxy server and your browser is Netscape
Navigator.
Step 1
Open Netscape.
Step 2
From the Edit menu, choose Preferences.
Step 3
In the Preferences dialog box under Category, choose Advanced > Proxies.
Step 4
On the right side of the Preferences dialog box under Proxies, either:
•
or
•
2.4.3 Remote Access to the ONS 15454
You can use LAN modems to access ONS 15454s from remote sites. The LAN modem must be
connected to the RJ-45 port on a TCC+ card or to the LAN pins on the ONS 15454 backplane. The LAN
modem must be properly configured for use with the ONS 15454. When the modem is installed, dial-up
access to the ONS 15454 is available using a PC or Solaris workstation modem.
2.4.4 TL1 Terminal Access to the ONS 15454
You can communicate with the ONS 15454 using TL1. To connect a TL1 terminal (or a PC running
terminal emulation software) to the ONS 15454, you can:
•
•
•
Cisco ONS 15454 Installation and Operations Guide
2-8
Deselect Use a proxy server to disable the service
Leave Use a proxy server selected and click Advanced. On the Proxy Setting dialog box under
Exceptions, enter the IP addresses of ONS 15454 nodes that you will access. Separate each address
with a semicolon. You can insert an asterisk for the host number to include all the ONS 15454s on
your network. Click OK to close each open dialog box.
Choose Direct connection to the Internet to bypass the proxy server
Choose Manual proxy configuration to add exceptions to the proxy server, then click View. On the
Manual Proxy Configuration dialog box under Exceptions, enter the IP addresses of the ONS 15454
nodes that you will access. Separate each address with a comma. Click OK to close each open dialog
box.
Use the DB-9 plug on the front panel of the TCC+ card or the CRAFT pins on the backplane. (For
a list of CRAFT pin assignments, see
Telnet to port 3083 with a LAN connection.
Start a TL1 session from CTC by selecting Open TL1 Session from the CTC Tools menu and
selecting the node where you want to hold the TL1 session in the Select Node dialog box.
Table 1-3 on page
1-35.)
Chapter 2
Software Installation
November 2001
Advertisement
Table of Contents
