Chapter 3 Node Setup; Before You Begin - Cisco 15454-TCC - Network Processor Card Operation Manual

Node Setup
This chapter explains how to set up a Cisco ONS 15454 node using the Cisco Transport Controller
(CTC). Topics include:
•
•
•
•
•
•
•
•
Lastly, the chapter includes a node checklist to help you keep track of the procedures you have
performed. See

3.1 Before You Begin

Before you begin node setup, review the following checklist to ensure you have the perquisite
information. Basic node information that you will provide need includes node name, contact, location,
date, and time. If the ONS 15454 will be connected to a network, you will need:
•
•
•
If you are responsible for setting up IP networking for the ONS 15454 network, see
Networking"
To create card protection groups, you will need to know:
•
•
Note You must be able to log into the node to complete node provisioning. If you cannot log into the node,
see "Connecting PCs to the ONS 15454" section on page
November 2001
Setting up general node information
Preparing the ONS 15454 to connect to networks
Changing the node IP address, default router, and subnet mask using the LCD
Creating, editing, and deleting ONS 15454 users and assigning user security levels
Setting the node timing references
Creating card protection groups
Viewing node inventory
Viewing CTC software versions
Chapter 2, "Software Installation"
The IP address and subnet mask to assign to the node and
The IP address of the default router.
If Dynamic Host Configuration Protocol is used, you will need the IP address of the DHCP server.
for more information.
The card protection scheme that will be used and what cards will be included in it.
The SONET protection topology that will be used for the node.
C H A P T E R
for general CTC information.
2-5.
Cisco ONS 15454 Installation and Operations Guide
3
Chapter 4, "IP
3-1