Table of Contents
Advertisement
Chapter 9
Ethernet Operation
For shared packet ring Ethernet, valid circuit sizes are STS-1, STS-3C and STS-6c.
Step 14
Verify that the Bidirectional checkbox is checked.
Note
Step 15
Click Next.
The Circuit Creation (Circuit Source) dialog box opens.
Step 16
From the Node menu, choose the circuit source.
Any shared packet ring node can serve as the circuit source.
Step 17
Choose Ethergroup from the Slot menu and click Next.
The Circuit Creation (Circuit Destination) dialog box opens.
Step 18
Choose the circuit destination from the Node menu.
Except for the source node, any shared packet ring node can serve as the circuit destination.
Step 19
Choose Ethergroup from the Slot menu and click Next.
Step 20
The Circuit Creation (Circuit VLAN Selection) dialog box opens.
Create the VLAN:
Step 21
Click the New VLAN tab.
a.
The Circuit Creation (Define New VLAN) dialog box opens
Figure 9-10 Choosing a VLAN name and ID
b.
Assign an easily-identifiable name to your VLAN.
c.
Assign a VLAN ID.
This VLAN ID number must be unique. It is usually the next available number not already assigned
to an existing VLAN (between 2 and 4093). Each ONS 15454 network supports a maximum of 509
user-provisionable VLANs.
d.
Click OK.
November 2001
You must manually provision the circuits if you are building a shared packet ring
configuration.
Ethernet Circuit Configurations
(Figure 9-10).
Cisco ONS 15454 Installation and Operations Guide
9-11
Advertisement
Table of Contents
