Procedure: Change Ip Address, Default Router, And Network Mask Using The Lcd; Figure 3-1 Setting Up General Network Information - Cisco 15454-TCC - Network Processor Card Operation Manual

Setting Up Network Information
Figure 3-1
Click Apply.
Step 3
Click Yes on the confirmation dialog box.
Step 4
Both ONS 15454 TCC+ cards will reboot, one at a time.

Procedure: Change IP Address, Default Router, and Network Mask Using the LCD

You can change the ONS 15454 IP address, subnet mask, and default router address using the Slot,
Status, and Port buttons on the front panel LCD.
The LCD reverts to normal display mode after 5 seconds of button inactivity.
Note
On the ONS 15454 front panel, repeatedly press the Slot button until Node appears on the LCD.
Step 1
Step 2 Repeatedly press the Port button until the following displays:
•
•
•
Cisco ONS 15454 Installation and Operations Guide
3-4
Setting up general network information
To change the node IP address, Status=IpAddress
To change the node network mask, Status=Net Mask
To change the default router IP address, Status=Default Rtr
(Figure 3-2)
Chapter 3 Node Setup
November 2001