Chapter 22
Configuring Multilink Point-to-Point Protocol Connections
Configuration Example for MLPoE LAC Switching
Example 22-9
also forwarding the DSL tags.
Example 22-9 MLPoE LAC Switching
aaa new-model
!
multilink bundle-name authenticated
vpdn enable
!
vpdn-group LACoe_LFI
request-dialin
protocol l2tp
domain hello_oe
dsl-line-info-forwarding
initiate-to ip 192.168.125.54
local name LACoe_LFI
l2tp tunnel password 0 lab
!
username LNSoe_LFI nopassword
!
bba-group pppoe global
virtual-template 800
vendor-tag dsl-sync-rate service
!
interface GigabitEthernet4/0/0
no ip address
negotiation auto
!
interface GigabitEthernet4/0/0.1
encapsulation dot1Q 800
pppoe enable group global
!
interface GigabitEthernet4/1/0
ip address 192.168.125.53 255.255.255.0
negotiation auto
!
interface Virtual-Template800
no peer default ip address
keepalive 30
ppp authentication pap
ppp multilink
ppp multilink links maximum 1
!
Configuration Examples of MLPoE at PTA
This section has the following configuration examples of the MLPoE at PTA feature:
•
•
OL-2226-23
shows how to configure the LAC for switching an MLPoE connection to the LNS, while
Configuring MLPoE over IEEE 802.1Q VLANs
Configuring MLPoE through RADIUS
Configuration Examples for Configuring MLP
Cisco 10000 Series Router Software Configuration Guide
22-41