Table of Contents
Advertisement
Chapter 10
Configuring Address Pools
The Overlapping IP Address Pools feature is described in the following topics:
•
•
•
•
•
Feature History for Overlapping IP Address Pools
Cisco IOS Release
12.2(4)BZ1
12.3(7)XI1
12.2(28)SB
Restrictions for Overlapping IP Address Pools
The software checks for duplicate addresses on a per-group basis. This means that you can configure
pools in multiple groups that could have possible duplicate addresses. You should only use this feature
in environments such as MPLS VPN where multiple IP address spaces are supported.
Configuration Tasks for Overlapping IP Address Pools
To configure the IP overlapping address pools feature, configure a local pool group as described in
"Configuring a Local Pool Group for IP Overlapping Address
Configuring a Local Pool Group for IP Overlapping Address Pools
To configure a local pool group, enter the following command in global configuration mode:
Command
Router(config)# ip local pool pool-name start-IP
[end-IP] [group group-name] [cache-size size]
OL-2226-23
Feature History for Overlapping IP Address Pools, page 10-17
Restrictions for Overlapping IP Address Pools, page 10-17
Configuration Tasks for Overlapping IP Address Pools, page 10-17
Verifying Local Pool Groups for IP Overlapping Address Pools, page 10-18
Configuration Examples for Overlapping IP Address Pools, page 10-18
Description
This feature was introduced on the Cisco 10000 series
router.
This feature was integrated into Cisco IOS Release
12.3(7)XI1.
This feature was integrated into Cisco IOS Release
12.2(28)SB.
Purpose
Configures a group of local IP address pools, gives the group a
name, and specifies a cache size.
Cisco 10000 Series Router Software Configuration Guide
Overlapping IP Address Pools
Required PRE
PRE1
PRE2
PRE2
Pools".
10-17
Advertisement
Table of Contents
Troubleshooting
