Creating An On-Demand Pvc With Infinite Range - Cisco 10000-2P2-2DC Software Configuration Manual

Chapter 8 Configuring ATM Permanent Virtual Circuit Autoprovisioning
Example 8-7
Example 8-7
Router(config)# int atm 3/0/0.1 multipoint
Router(config-subif)# atm pppatm passive
Router(config-subif)# range pvc 100/100 100/200
Router(config-subif-atm-range)# pvc-in-range 100/100
Router(config-subif-atm-range-pvc)# create on-demand
Router(config-subif-atm-range-pvc)# idle-timeout 300

Creating an On-Demand PVC With Infinite Range

To create an on-demand PVC with infinite range, enter the following commands beginning in global
configuration mode:
Command
Step 1
Router(config)# vc-class atm name
Step 2
Router(config-vc-class)# create on-demand
Step 3
Router(config-vc-class)# idle-timeout
[time-out-in-seconds]
[minimum-traffic-in-kbps]
Step 4
Router(config)# interface atm slot/0
Step 5
Router(config-if)# class-int name
Example 8-8
the class to the main ATM interface. All the PVCs on the main interface will be autoprovisioned; this
configuration is also known as infinite range.
Example 8-8
Router(config)# vc-class atm myclass
Router(config-vc-class)# create on-demand
Router(config-vc-class)# idle-timeout 300
Router(config)# int atm 3/0/0
Router(config-if)# class-int myclass
OL-2226-23
enables autoprovisioning on PVC 100/100 in PVC range 100/100 to 100/200.
Enabling ATM PVC Autoprovisioning on a PVC Within a PVC Range
Purpose
Creates a VC class and enters vc-class configuration mode.
Enables PVC autoprovisioning.
Note
(Optional) Enables the idle-timeout timer on the on-demand PVC.
The default time-out-in-seconds is 0 (no idle-timeout).
The Cisco 10000 series router waits until the traffic on a
particular VC is processed before tearing down the VC, even if
you specify the minimum-traffic-in-kbps option or if the VC is
idle during the idle-timeout period.
Specifies the ATM interface.
You can configure infinite range only on a main ATM interface.
When you use the class-int command to attach an ATM VC class
to a subinterface, the create on-demand command is ignored.
Attaches a VC class to an ATM interface.
creates a VC class named myclass, enables PVC autoprovisioning on the class, and attaches
Configuring an On-Demand PVC With Infinite Range
Configure additional VC parameters as appropriate. For
more information, see the "VC Class" section on page 8-3
or the "Creating a VC Class Examples" section in the
Cisco IOS Wide-Area Networking Configuration Guide.
Cisco 10000 Series Router Software Configuration Guide
ATM PVC Autoprovisioning
8-11