Atom - Cisco 10000-2P2-2DC Software Configuration Manual

Ethernet/VLAN to ATM AAL5 Interworking

AToM

Figure 21-9
Figure 21-9
This section explains the following AToM configurations and their examples:
•
•
ATM AAL5 to Ethernet Port
You can configure the ATM AAL5 to Ethernet Port feature on a PE1 router using the following steps:
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
You can configure the ATM AAL5 to Ethernet Port feature on a PE2 router using the following steps:
1.
2.
3.
4.
5.
6.
7.
8.
9.
Cisco 10000 Series Router Software Configuration Guide
21-14
illustrates different AToM configurations.
AToM Model for CLI Commands
CE1
PE1
ATM AAL5 to Ethernet Port, page 21-14
Configuring ATM AAL5 to Ethernet VLAN 802.1Q, page 21-15
config t
mpls label protocol ldp
interface Loopback<name>
ip address local-ip-address local-mask
pseudowire-class name
encapsulation mpls
interworking ethernet|ip
interface atm slot/subslot/port
pvc vpi/vci l2transport
encapsulation aal5snap
xconnect remote-ip-address vc-id pw-class name
config t
mpls label protocol ldp
interface Loopback<name>
ip address local-ip-address local-mask
pseudowire-class name
encapsulation mpls
interworking ip
interface [ fastethernet | gigabitethernet ] slot/subslot/port
xconnect remote-ip-address vc-id pw-class name
Chapter 21 Configuring L2VPN Interworking
P PE2 CE2
OL-2226-23