Audience; Document Organization; Chapter 2 Scalability And Performance; Chapter 3 Configuring Remote Acces To Mpl Vpn - Cisco 10000-2P2-2DC Software Configuration Manual

Audience

Cisco IOS Release
Release 12.3(7)XI1
Description
Added the new features listed in the
page
Audience
This guide is designed for system and network managers responsible for configuring broadband
aggregation, leased-line, and MPLS services and on the Cisco 10000 series router. The manager should
be experienced using Cisco IOS software and be familiar with the operation of the
Cisco 10000 series router.

Document Organization

This guide contains the following chapters:
Chapter Title
Chapter 1 Broadband Aggregation Overview
Chapter 2 Scalability and Performance
Chapter 3 Configuring Remote Access to MPLS
VPN
Chapter 4 Configuring Multiprotocol Label
Switching
Chapter 5 Configuring Layer 2 Tunnel Protocol
Access Concentrator and Network Server
Chapter 6 Configuring PPPoE over Ethernet and
IEEE 802.1Q VLANs
Chapter 7 Configuring IP Unnumbered over VLAN Describes the IP Unnumbered over VLAN feature that helps
Cisco 10000 Series Router Software Configuration Guide
xxx
Part Number
OL-2226-07
1-26.
Publication Date
August, 2004
"New Features in Cisco IOS Release 12.3(7)XI1" section on
Description
Lists new features and enhancements in each release; describes
hardware requirements. Provides examples of broadband and
leased-line architecture models.
Describes limitations and restrictions, and how to configure the
Cisco 10000 series router for high scalability.
Describes the Remote Access (RA) to MPLS VPN feature that
allows the service provider to offer a scalable end-to-end VPN
service to remote users.
Describes MPLS-related features, such as BGP Multipath load
sharing, Session Limit per VRF, and Half-duplex VRF.
Describes how to configure the Cisco 10000 series router as a
Layer 2 Tunnel Protocol Access Concentrator (LAC) or as an
L2TP Network Server (LNS). The managed LNS feature of the
Cisco 10000 series router enables the router to assign a
subscriber session to a VRF instance and route the session
within the VRF to the destination network.
Describes the PPPoE over Ethernet feature that enables direct
connection to an Ethernet interface. Also describes the
IEEE 802.1Q VLANs feature that enables the
Cisco 10000 series router to support PPPoE over IEEE 802.1Q
encapsulated VLANs using Gigabit Ethernet.
service providers to conserve IP address space for service
provider configurations that include Ethernet VLAN
subinterfaces.
About This Guide
OL-2226-23