Cisco 10000-2P2-2DC Software Configuration Manual page 461

Chapter 21 Configuring L2VPN Interworking
3.
4.
5.
6.
7.
Note
Note
The following example shows how you can configure the ATM AAL5 to Ethernet Port feature on a PE
router using routed interworking:
config t
interface atm 2/0/0
pvc 0/200 l2transport
encapsulation aal5snap
interface gigabitethernet 5/1/0
connect atm-enet gigabitethernet 5/1/0 atm 2/0/0 0/200 interworking ip
ATM AAL5 to Ethernet VLAN 802.1Q
You can configure the ATM AAL5 to Ethernet VLAN 802.1Q feature on a PE router using the following
steps:
1.
2.
3.
4.
5.
6.
7.
Note
The following example shows how to configure the ATM AAL5 to Ethernet VLAN 802.1Q feature on a
PE router using bridged interworking:
config t
interface atm 2/0/0
interface gigabitethernet 5/1/0.3
connect atm-vlan gigabitethernet 5/1/0.3 atm 2/0/0 0/200 interworking ethernet
OL-2226-23
pvc vpi/vci l2transport
encapsulation aal5snap
interface [ fastethernet | gigabitethernet ] slot/subslot/port
no ip address
connect connection-name [ fastethernet | gigabitethernet ] slot/subslot/port atm slot/subslot/port
vpi/vci interworking ethernet|ip
The order of the interfaces in the connect command is not important.
For configuring routed interworking on the ATM AAL5 to Ethernet Port feature, enter all
commands except the no ip address command.
config t
interface atm slot/subslot/port
pvc vpi/vci l2transport
encapsulation aal5snap
interface [ fastethernet | gigabitethernet ] slot/subslot/port.subinterface
encapsulation dot1q VLAN-ID
connect connection-name [ fastethernet | gigabitethernet ] slot/subslot/port.subinterface atm
slot/subslot/port vpi/vci interworking ethernet|ip
The order of the interfaces in the connect command is not important.
pvc 0/200 l2transport
encapsulation aal5snap
encapsulation dot1q 2
Ethernet/VLAN to ATM AAL5 Interworking
Cisco 10000 Series Router Software Configuration Guide
21-13