Verifying Local Pool Groups For Ip Overlapping Address Pools; Configuration Examples For Overlapping Ip Address Pools; Generic Ip Overlapping Address Pools Example - Cisco 10000-2P2-2DC Software Configuration Manual

Overlapping IP Address Pools

Verifying Local Pool Groups for IP Overlapping Address Pools

To verify that you have successfully configured a pool group, enter the following commands in
privileged EXEC mode and check the resulting output for the pool group name:
Command
Router# show ip local pool [pool-name [group
group-name]]
Router# show ip local pool
Router# show ip local pool pool-name
Router# show ip local pool group
Router# show ip local pool group group-name

Configuration Examples for Overlapping IP Address Pools

This section provides the following configuration examples:
•
•

Generic IP Overlapping Address Pools Example

The following example shows the configuration of two pool groups and includes pools in the base system
group. In this example:
•
•
•
•
•
ip local pool p1_g1 10.1.1.1 10.1.1.50 group grp1
ip local pool p2_g1 10.1.1.100 10.1.1.110 group grp1
ip local pool p1_g2 10.1.1.1 10.1.1.40 group grp2
ip local pool lp1 10.1.1.1 10.1.1.10
ip local pool p3_g1 10.1.2.1 10.1.2.30 group grp1
ip local pool p2_g2 10.1.1.50 10.1.1.70 group grp2
ip local pool lp2 10.1.2.1 10.1.2.10
The preceding example shows pool names that provide an easy way to associate a pool name with a
Note
group (when the pool name stands alone). This association is an operational convenience. There is no
required relationship between the names used to define a pool and the name of the group.
Cisco 10000 Series Router Software Configuration Guide
10-18
Generic IP Overlapping Address Pools Example, page 10-18
IP Overlapping Address Pools for VPNs and VRFs Example, page 10-19
Pool group grp1 consists of pools p1_g1, p2_g1, and p3_g1.
Pool group grp2 consists of pools p1_g2 and p2_g2.
Pools lp1 and lp2 are members of the base system group.
The IP address 10.1.1.1 overlaps grp1, grp2, and the base system group.
No overlapping addresses occur within any group including the unnamed base system group, which
consists of pools lp1 and lp2.
Purpose
Displays statistics for defined IP address pools.
Displays statistics for all pools configured.
Displays statistics for a specific pool you specify.
Displays statistics for all pools in a base system group.
Displays all pools in a specified group.
Chapter 10 Configuring Address Pools
OL-2226-23