Table of Contents
Advertisement
Chapter 20
Configuring L2 Virtual Private Networks
encapsulation mpls
!
interface GigabitEthernet1/0/0
xconnect 1.1.1.1 1 pw-class eompls
remote link failure notification
!
Example 20-19 Disabling Remote Ethernet Port Shutdown under the Xconnect Configuration
pseudowire-class eompls
encapsulation mpls
!
interface GigabitEthernet1/0/0
xconnect 1.1.1.1 1 pw-class eompls
no remote link failure notification
!
To see the operational status of all remote L2 tunnels by interface, enter show interface and show ip
interface brief commands, as shown in
Example 20-20 Operational Status for All Remote L2 Tunnels by Interface
router# show interface GigabitEthernet1/0/0
GigabitEthernet1/0/0 is L2 Tunnel remote down, line protocol is up
Hardware is Half-height Gigabit Ethernet MAC Controller, address is 0009.b68f.9b18 (bia
0009.b68f.9b18)
MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec,
......
......
router# sh ip interface brief
Interface
FastEthernet0/0/0
GigabitEthernet1/0/0
GigabitEthernet2/0/0
Enter show controller and show controller interface commands to see the port transceiver state, as
shown in
Example 20-21 Port Transceiver State
router# show controller GigabitEthernet1/0/0
Interface GigabitEthernet1/0/0(idb 0x4FB5CA7C)
Hardware is Half-height Gigabit Ethernet MAC Controller, network connection mode is auto
network link is L2 Tunnel remote down
loopback type is none
......
Configuring Ethernet over MPLS with VLAN ID Rewrite
The VLAN ID Rewrite feature enables you to use VLAN interfaces with different VLAN IDs at both
ends of the tunnel. The Cisco 10000 series router automatically performs VLAN ID Rewrite on the
disposition PE router. There is no configuration required.
OL-2226-23
IP-Address
24.3.8.1
unassigned
30.1.1.1
Example
20-21.
Example
20-20.
OK? Method Status
YES NVRAM
up
YES NVRAM
L2 Tunnel remote down up
YES manual up
Cisco 10000 Series Router Software Configuration Guide
Configuration Tasks for L2VPN
Protocol
up
up
20-27
Advertisement
Table of Contents
Troubleshooting
