Table of Contents
Advertisement
Configuration Tasks for L2VPN
Configuring OAM Cell Emulation for ATM AAL5 SDU Support over MPLS in VC Class Configuration
Mode
The following steps explain how to configure OAM cell emulation as part of a VC class. You can then
apply the VC class to an interface, a subinterface, or a VC. When you configure OAM cell emulation in
VC class configuration mode and then apply the VC class to an interface, the settings in the VC class
apply to all the VCs on the interface, unless you specify a different OAM cell emulation value at a lower
level, such as the subinterface or VC level.
For example, you can create a VC class that specifies OAM cell emulation and sets the rate of AIS cells
to every 30 seconds. You can apply the VC class to an interface. Then, for one PVC, you can enable OAM
cell emulation and set the rate of AIS cells to every 15 seconds. All the PVCs on the interface use the
cell rate of 30 seconds, except for the one PVC that was set to 15 seconds.
To enable OAM cell emulation as part of a VC class and apply it to an interface, enter the following
commands beginning in global configuration mode:
Command
Step 1
Router(config)# vc-class atm name
Step 2
Router(config-vc-class)# encapsulation layer-type
Step 3
Router(config-vc-class)# oam-ac emulation-enable
[ais-rate]
Step 4
Router(config-vc-class)# oam-pvc manage [frequency]
Step 5
Router(config-vc-class)# exit
Step 6
Router(config)# interface type slot/port
Step 7
Router(config-if)# class-int vc-class-name
Step 8
Router(config-if)# pvc [name] vpi/vci l2transport
Step 9
Router(config-if-atm-l2trans-pvc)# xconnect
peer-router-id vcid encapsulation mpls
Cisco 10000 Series Router Software Configuration Guide
20-18
Chapter 20
Configuring L2 Virtual Private Networks
Purpose
Creates a VC class and enters VC class
configuration mode.
Configures the ATM adaptation layer (AAL) and
encapsulation type.
Enables OAM cell emulation for AAL5 over MPLS.
The ais-rate variable lets you specify the rate at
which AIS cells are sent.
The range is 0 to 60 seconds. The default is 1 second,
which means that one AIS cell is sent every second.
Enables the PVC to generate end-to-end OAM
loopback cells that verify connectivity on the virtual
circuit.
The optional frequency variable is the interval
between transmission of loopback cells and ranges
from 0 to 600 seconds. The default value is 10
seconds.
Returns to global configuration mode.
Specifies the interface by type, slot, and port
number, and enters interface configuration mode.
Applies a VC class to the ATM main interface or
subinterface.
You can also apply a VC class to a PVC.
Note
Creates or assigns a name to an ATM PVC.
The l2transport keyword indicates that the PVC is
a switched PVC instead of a terminated PVC. Enters
L2 Transport VC configuration mode.
Binds the attachment circuit to a pseudowire VC.
OL-2226-23
Advertisement
Table of Contents
Troubleshooting
