Table of Contents
Advertisement
Chapter 6
Configuring PPPoE over Ethernet and IEEE 802.1Q VLAN
Command
Step 3
Router(config-vpdn)# accept-dialin
Step 4
Router(config-vpdn-acc-in)# protocol pppoe
Step 5
Router(config-vpdn-acc-in)# virtual-template
template-number
Step 6
Router(config-vpdn)# pppoe limit per-vlan
number
Step 7
Router(config-vpdn)# pppoe limit per-mac
per-mac-limit
Step 8
Router(config-vpdn)# pppoe limit max-sessions
number
You cannot simultaneously configure a broadband aggregation (BBA) group for PPPoE and a VPDN
Note
group for PPPoE. If you configure a BBA group and then you configure a VPDN group, the protocol
command in VPDN accept-dialin configuration mode does not include an option for PPPoE (for
example, you cannot specify the protocol pppoe command). Use the no bba-group pppoe command to
re-enable the pppoe option for the protocol command.
Configuring PPPoE in a BBA Group
Cisco IOS Release 12.2(15)BX does not support the configuration of BBA groups using RADIUS. You
Note
must configure BBA groups manually.
To configure a broadband aggregation (BBA) group for PPPoE and to link it to the appropriate virtual
template interface, enter the following commands beginning in global configuration mode:
Command
Step 1
Router(config)# bba-group pppoe {name |
global}
Step 2
Router(config-bba-group)# virtual-template
template-number
Step 3
Router(config-bba-group)# sessions per-mac
limit per-MAC session limit
Step 4
Router(config-bba-group)# sessions per-vlan
limit per-VLAN session limit
Step 5
Router(config-bba-group)# sessions per-vc
limit per-VC session limit
OL-2226-23
Purpose
Creates an accept dial-in VPDN group.
Specifies the VPDN group to be used to establish
PPPoE sessions.
Specifies the virtual template interface to use to clone virtual
access interfaces (VAIs).
(Optional) Specifies the maximum number of PPPoE sessions
under each VLAN.
(Optional) Specifies the maximum number of sessions per
MAC address for each PPPoE port that uses the group.
(Optional) Specifies the maximum number of PPPoE sessions
that can be terminated on this router from all interfaces.
Purpose
Configures a BBA group to be used to establish PPPoE
sessions.
name identifies the BBA group. You can have multiple BBA
groups.
global is the default BBA group used for ATM connections
when a BBA group name is not specified.
Specifies the virtual template interface to use to clone virtual
access interfaces (VAIs).
(Optional) Specifies the maximum number of sessions per
MAC address for each PPPoE port that uses the group.
(Optional) Specifies the maximum number of PPPoE
sessions under each VLAN.
(Optional) Specifies the maximum number of PPPoE
sessions to be terminated on this router from all interfaces.
Cisco 10000 Series Router Software Configuration Guide
PPPoE over IEEE 802.1Q VLANs
6-9
Advertisement
Table of Contents
Troubleshooting
