Mlp Bundles; Restrictions For Mlp Bundles; Mlp Bundles And Ppp Links - Cisco 10000-2P2-2DC Software Configuration Manual

Chapter 22 Configuring Multilink Point-to-Point Protocol Connections
Cisco IOS Release
12.2(31)SB2
12.2(33)SB
12.2(33)SB2
12.2(33)XNE

MLP Bundles

MLP combines multiple physical links into a logical bundle called an MLP bundle (see
MLP bundle is a single, virtual interface that connects to the peer system. Having a single virtual
interface enables fancy queuing and QoS to be applied to the traffic on the virtual interface (for example,
policing and traffic shaping can be applied to the traffic flows). Each individual link to the peer system
might be doing some form of fancy queuing, but none of the links knows about the traffic on the other
parallel links. Fancy queuing and QoS cannot be applied uniformly to the entire aggregate traffic
between the system and its peer system. A single virtual interface also simplifies the task of monitoring
traffic to the peer system (for example, traffic statistics are all on one interface).
Figure 22-1
An endpoint discriminator is used to identify the member links of the MLP bundle.

Restrictions for MLP Bundles

The router supports links equal to T1/E1 or less for MLPPP bundling. You cannot bundle high-speed
links (for example, E3) because the router can store only 50 ms of data based on the E1 speed.

MLP Bundles and PPP Links

MLP works with fully functional Point-to-Point Protocol (PPP) interfaces. An MLP bundle can consist
of a PPP over serial link and a PPP over ATM link. As long as each link behaves like a standard serial
interface, the mixed links work properly in a bundle.
OL-2226-23
Description
Support was added for the PRE3 and the valid multilink
interface ranges for MLP over serial or multi-VC MLP
over ATM changed from 1 to 9999 (Release 12.2(28)SB
and later) to from 1 to 9999 and 65,536 to 2,147,483,647.
The MLPPP on LNS feature was introduced on the Cisco
10000 series router that is supported on the PRE3 and
PRE4. This feature is not supported on the PRE2.
The MLPoE LAC Switching feature was introduced on the
Cisco 10000 series router.
The MLPoE at PTA feature was introduced on the Cisco
10000 series router.
Multilink PPP Bundle
Point-to-Point
Cisco 10000 Series Router Software Configuration Guide
MLP Bundles
Required PRE
PRE3
PRE3 and PRE4
PRE3
PRE3 and PRE4
Figure 22-1). An
22-3