Configuring Mlpoe Over Ieee 802.1Q Vlans; Configuring Mlpoe Through Radius - Cisco 10000-2P2-2DC Software Configuration Manual

Configuration Examples for Configuring MLP

Configuring MLPoE over IEEE 802.1Q VLANs

Example 22-10
Example 22-10 Configuring MLPoE over IEEE 802.1Q VLANs
policy-map policy_mlpoe_out
class class-default
policy-map policy_mlpoe_in
class class-default
!
!
bba-group pppoe PPPoE
virtual-template 3
sessions per-vc limit 65530
sessions per-mac limit 65530
sessions per-vlan limit 8000 inner 1
!
interface Loopback3
ip address 13.0.0.1 255.0.0.0
!
interface GigabitEthernet1/0/0
ip address 1.0.0.1 255.255.0.0
negotiation auto
!
interface GigabitEthernet1/0/0.1
encapsulation dot1Q 2
pppoe enable group PPPoE
no snmp trap link-status
!
interface Virtual-Template3
ip unnumbered Loopback3
peer default ip address pool MLPoEpool
ppp authentication pap
ppp multilink
ppp multilink links max 1
ppp multilink interleave
ppp multilink fragment delay 8
service-policy output policy_mlpoe_out
service-policy input policy_mlpoe_in
!
ip local pool MLPoEpool 13.1.0.2 13.1.255.255
!
!
end
Note As MLPoE supports only single-member bundles, the ppp multilink links maximum 1 command must
be configured to restrict the number of links that join the bundle.

Configuring MLPoE through RADIUS

Example 22-11
Authentication Dial-In User Service (RADIUS):
Example 22-11 Configuring MLPoE through RADIUS
cisco@domain_1
Password="cisco"
Cisco 10000 Series Router Software Configuration Guide
22-42
shows how to configure the PPPoE over IEEE 802.1Q VLANs:
shape average 2048000
shape average 512000
shows how to configure the PPPoE on multiple link bundles through Remote
Service-Type=Framed-User,
Chapter 22 Configuring Multilink Point-to-Point Protocol Connections
OL-2226-23