Cisco 10000-2P2-2DC Software Configuration Manual page 474

Ethernet/VLAN to Frame Relay Interworking
xconnect 10.0.0.100 150 pw-class fr-eth
FR DLCI to Ethernet VLAN 802.1Q
To configure the FR DLCI to Ethernet VLAN 802.1Q feature on a PE1 router, use the following steps:
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
14.
To configure the FR DLCI to Ethernet VLAN 802.1Q feature on a PE2 router, use the following steps:
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
Note
The following example shows how to configure the FR DLCI to Ethernet VLAN 802.1Q feature on a
PE1 router using bridged interworking:
config t
mpls label protocol ldp
interface Loopback100
ip address 10.0.0.100 255.255.255.255
pseudowire-class fr-vlan
Cisco 10000 Series Router Software Configuration Guide
21-26
config t
mpls label protocol ldp
interface Loopback<name>
ip address local-ip-address local-mask
pseudowire-class name
encapsulation mpls
interworking ethernet|ip
frame-relay switching
interface serial slot/subslot/port[:channel | .channel]
encapsulation frame-relay
frame-relay intf-type dce
frame-relay interface-dlci DLCI switched
connect mpls serial slot/subslot/port[:channel | .channel] DLCI l2transport
xconnect remote-ip-address vc-id pw-class name
config t
mpls label protocol ldp
interface Loopback<name>
ip address local-ip-address local-mask
pseudowire-class name
encapsulation mpls
interworking ethernet|ip
interface [ fastethernet | gigabitethernet ] slot/subslot/port.subinterface
encapsulation dot1q VLAN-ID
xconnect remote-ip-address vc-id pw-class name
In the case of an FR DLCI to VLAN, the PE2 configuration includes the interworking command
for both bridged and routed interworking.
Chapter 21 Configuring L2VPN Interworking
OL-2226-23