New Features In Cisco Ios Release 12.2(31)Sb5; New Features In Cisco Ios Release 12.2(31)Sb3 - Cisco 10000-2P2-2DC Software Configuration Manual

Chapter 1 Broadband Aggregation and Leased-Line Overview
•
•
•
•
•

New Features in Cisco IOS Release 12.2(31)SB5

In Cisco IOS Release 12.2(31)SB5 support was added for the following features:
•
•

New Features in Cisco IOS Release 12.2(31)SB3

In Cisco IOS Release 12.2(31)SB3, support was added on the Cisco 10000 series router for the following
features and functionality:
•
•
Note
OL-2226-23
IEEE 802.1Q Tunneling (QinQ) for AToM
For more information, see the
IGP Convergence Acceleration
This feature allows faster failover of IGP routes in load balanced situation.
Gigabit EtherChannel-Enhancements
For more information, see
ISG:Flow Control: Flow redirect (PXF scaling)
For more information, see
VRF-Aware VPDN Tunnels
This feature places broadband traffic in a VRF based on the VPDN group. This allows more flexible
DSL service at the Layer 2 Network Server (LNS).
Generic Routing Encapsulation (GRE) Tunnel IP Source and Destination VRF Membership
For more information, see the
on page 27-1.
Per Session Queuing and Shaping for PPPoE Over VLAN Using RADIUS
For more information, see the "Shaping PPPoE Over VLAN Sessions Using RADIUS" section in
the "Configuring Dynamic Subscriber Services" chapter of the Cisco 10000 Series Router Quality
of Service Configuration Guide, located at the following URL:
http://www.cisco.com/en/US/products/hw/routers/ps133/products_configuration_guide_book0918
6a00805b9497.html
IS-IS-MIB
For more information, see the following URL:
http://www.cisco.com/univercd/cc/td/doc/product/software/ios122/122newft/122limit/122sg25/
ismibspt.htm
QoS: MQC Classification, Policing, and Marking on LAC
Support for this feature on the PRE3 was introduced in Cisco IOS Release 12.2(31)SB2.
For detailed information about this feature, see the "Shaping Traffic" chapter in the
Cisco 10000 Series Router Quality of Service Configuration Guide, located at the following URL:
http://cisco.com/en/US/products/hw/routers/ps133/products_configuration_guide_book09186a008
05b9497.html
"IEEE 802.1Q Tunneling for AToM—QinQ" section on page 20-22
Chapter 23, "Configuring Gigabit EtherChannel Features"
"Layer 4 Redirect Scaling" section on page 2-5
"GRE Tunnel IP Source and Destination VRF Membership" section
Cisco 10000 Series Router Software Configuration Guide
New Features, Enhancements, and Changes
1-19