Configuration Example - Cisco 1100 Series Hardware Installation Manual

ROM Monitor Overview and Basic Procedures

Configuration Example

rommon 5 > confreg
Configuration Summary
(Virtual Configuration Register: 0x0)
enabled are:
[ 0 ] break/abort has effect
[ 1 ] console baud: 9600
boot:...... the ROM Monitor
do you wish to change the configuration? y/n [n]: y
enable "diagnostic mode"? y/n [n]:
disable "break/abort has effect"? y/n [n]:
enable "ignore system config info"? y/n [n]:
change console baud rate? y/n [n]:
change the boot characteristics? y/n [n]:
Configuration Summary
(Virtual Configuration Register: 0x0)
enabled are:
[ 0 ] break/abort has effect
[ 1 ] console baud: 9600
boot:...... the ROM Monitor
do you wish to change the configuration? y/n [n]:
Upgrading the ROMmon for a Router
Use this procedure to upgrade the ROMmon on a router:
SUMMARY STEPS
1. (Optional) Run the show platform command or the show rom-monitor slot command on the router to
see the current release numbers of ROMmon on the hardware.
2. If the ROMmon image has not been copied onto the router, copy the PKG file that is made available as
part of this ROMmon release onto the bootflash: or usb[0-1]: file system using the copy source-location
destination-location command.
3. Run the dir file-system command to verify that the ROMmon file is copied into the specified directory.
4. Run the upgrade rom-monitor filename location all command to begin the ROMmon image upgrade,
where location is the path to the ROMmon file.
5. Messages pertaining to the upgrade are displayed on the console. After the display of these messages stops
and the router prompt is available, run the reload command to reload the router.
6. If autoboot has not been enabled by using the config-register 0x2102 command, run the boot
filesystem:/file-location command at the ROMmon prompt to boot the Cisco IOS XE image, where
filesystem:/file-location is the path to the consolidated package file. The ROMmon upgrade is not permanent
for any piece of hardware until the Cisco IOS XE image is booted.
7. Run the enable command at the user prompt to enter the privileged EXEC mode after the boot is complete.
8. Run the show platform command or the show rom-monitor slot command to verify whether the ROMmon
has been upgraded.
Hardware Installation Guide for the Cisco 1100 Series Integrated Services Router
Exiting ROM Monitor Mode
47