Verifying The Configuration Of A Range Of Subinterfaces - Cisco 10000-2P2-2DC Software Configuration Manual

VLAN Range

Verifying the Configuration of a Range of Subinterfaces

To verify the configuration of a range of subinterfaces for VLAN encapsulation, enter the following
commands in privilege EXEC mode:
Command
Router# show running-config
Router# show interface
Router# show interface interface-type
slot/interface.subinterface
Cisco 10000 Series Router Software Configuration Guide
6-18
Chapter 6 Configuring PPPoE over Ethernet and IEEE 802.1Q VLAN
Purpose
Displays the current configuration, including information about
the interfaces and subinterfaces configured on the router and the
type of encapsulation configured for each interface.
Displays information about all interfaces and subinterfaces
configured on the router, including the type of encapsulation
configured for each interface.
Displays information about the interface or subinterface you
specify, including the type of encapsulation configured.
OL-2226-23