Cisco 10000-2P2-2DC Software Configuration Manual page 176

Layer 2 Access Concentrator
Configuring a Static Domain Name on a Virtual Circuit Class
To configure a static domain name on a VC class, enter the following commands beginning in global
configuration mode:
Command
Step 1
Router> enable
Step 2
Router# config terminal
Step 3
Router(config)# vc-class atm
vc-class-name
Step 4
Router(config-vc-class)# encapsulation
aal5mux ppp Virtual-Template number
Step 5
Router(config-vc-class)# vpn service
domain-name
Step 6
Router(config-vc-class)# exit
Step 7
Router(config)# interface atm
0/0/0[.subinterface-number] {multipoint |
point-to-point | tag-switching}
Step 8
Router(config-subif)# atm pppatm passive
Step 9
Router(config-subif)# class-int
vc-class-name
In Example
to the VCs on an ATM subinterface.
Example 5-2
!
vc-class ATM MyClass
interface ATM 0/0/0.99 multipoint
Verifying the Static Domain Name
To verify that you successfully configured the static domain name, enter the show running-config
command in privileged EXEC mode.
Cisco 10000 Series Router Software Configuration Guide
5-10
Chapter 5
5-2, the static domain name net.com is assigned to a VC class. The VC class is then assigned
Configuring a Static Domain Name on a VC Class
encapsulation aal5ciscoppp Virtual-Template1
vpn service net.com
!
atm pppatm passive
class-int MyClass
no ip directed-broadcast
pvc 20/40
pvc 30/33
!
Configuring the Layer 2 Tunnel Protocol Access Concentrator and Network Server
Purpose
Enters privileged EXEC mode.
Enters global configuration mode.
Creates and names a map class.
Configures the ATM adaptation layer (AAL) and encapsulation
type for an ATM PVC, SVC, VC class, or VC bundle.
mux ppp is for a MUX-type VC running IETF-compliant PPP
over ATM. You must use the Virtual-Template number argument
to identify the virtual template. The mux ppp keyword applies to
ATM PVCs only.
Configures the static domain name on the VC class.
Returns to global configuration mode.
Specifies the ATM interface and optional subinterface.
Places the sessions on the subinterface in passive (listening)
mode.
Applies the VC class to all VCs on the ATM interface or
subinterface.
OL-2226-23