Configuring Call Appearance Per Line - Cisco 521SG - Unified IP Phone VoIP Administration Manual

Configuring Lines
Configuring a Line Key
Cisco Small Business SPA300 Series, SPA500 Series, and WIP310 IP Phone Administration Guide

Configuring Call Appearance Per Line

In the Phone tab, Call Appearance Per Line (under Miscellaneous Line Key
Settings) lets you choose the number of calls per line button. The default value is 2.
This option is not supported on the Cisco SPA501G and Cisco SPA301 phones.
Also, this feature is only supported when the phones are operating in SIP mode.
When you increase the number of calls per line to a value greater than 2, you must
set the following:
Line ID Mapping (under Miscellaneous Line Key Settings) to Horizontal
•
First.
Line Navigation (under Miscellaneous Line Key Settings) to Per Call.
•
• Programmable Softkey Enable (under Programmable Softkeys) to Yes.
When the maximum numbers of calls per phone is reached, the phone does not
allow you to make a new call and rejects incoming calls.
number of calls per phone for each model.
Table 1 Maximum Number of Allowed Calls Per Phone
Phone
Cisco SPA303, SPA502G,
SPA504G
Cisco_SPA508G
Cisco SPA509G
Cisco SPA512G and
Cisco SPA514G
Cisco SPA525G or
Cisco SPA525G2
Table 1
Maximum Number of Calls
10
16
24
10
10
2
lists the maximum
40