Configuring LED Patterns
Cisco Small Business SPA300 Series, SPA500 Series, and WIP310 IP Phone Administration Guide
u=on/off/on/off/etc.
This is a user-defined blinking pattern used only when p = ud. It consists of up to 4
pairs of on/off duration in seconds with up to 2 decimal places; each value is
separated by a forward slash (/).
LED Script Examples
c=r;p=sb
Color is red and pattern is slow blink.
c=o
LED is off.
c=g
Color is green and pattern is steady on (default).
c=a;p=ud;u=.1/.1/.1/.1/.1/.9
Color is amber (orange) and the blink pattern is: 100ms on, 100ms off, 100ms on,
100ms off, 100ms on, 900ms off
LED Pattern
The administrator can also specify a different color and pattern for each of the
following states of the call appearance.
•
Idle: This call appearance is not in use. It can be used to make outbound call
on this phone
•
Local Seized: This call appearance has been seized by this phone to
prepare for an outbound call
•
Local Progressing: This phone is making an outbound call that is
progressing
•
Local Active: This phone is engaged in a connected call on this call
appearance
•
Local Ringing: This phone is ringing for an incoming call on this call
appearance
•
Local Held: This phone has placed this call appearance on hold
9
209