Assigning Busy Lamp Field, Call Pickup, Or Speed Dial Functions To Unused Lines - Cisco 521SG - Unified IP Phone VoIP Administration Manual

Configuring Lines

Assigning Busy Lamp Field, Call Pickup, or Speed Dial Functions to Unused Lines

STEP 4
STEP 5
Assigning Busy Lamp Field, Call Pickup, or Speed Dial
Functions to Unused Lines
Cisco Small Business SPA300 Series, SPA500 Series, and WIP310 IP Phone Administration Guide
Choose the line key to configure (line 5 in this example):
a. From the Extension drop down list, choose Disabled.
b. From the Share Call Appearance drop-down list, choose private.
c. Enter the following string in the Extended Function field:
fnc=prk;sub=05@domain.com
where:
- fnc: function
- prk: call park
- sub: call park orbit, or location where the call is parked. Valid value range
is from 01 through 10. In this example, 5 is used.
- domain.com: phone domain, usually the same as the proxy value in the
Ext 1 tab. You can also use fnc=prk;sub=05@$PROXY to set this value.
Click Submit All Changes.
You can configure unused or idle lines on a Cisco SPA300 Series or Cisco SPA500
Series IP phones to interact with another line in the system. For example, if you
have two idle lines on an assistant's phone, you can configure those lines to show
the status of a supervisor's phone (Busy Lamp Field [BLF]). You can also configure
the idle lines so that they can be used to speed dial the supervisor's phone, or pick
up calls that are ringing on the supervisor's phone.
A monitored extension must be private, not shared. Additionally, if using the
Cisco SPA9000 for call control, an extension can only be monitored by one other
extension.
For detailed instructions on configuring the phones with the BroadSoft Busy Lamp
Field (BLF) feature, see
BLF , available on the Cisco Support Community at
https://supportforums.cisco.com/docs/DOC-9977
Configuring SPA303 and 5xxG IP Phones with Broadsoft's
2
43