Cisco 521SG - Unified IP Phone VoIP Administration Manual page 30

Getting Started
Using IVR on IP Phones Without Screens
Cisco Small Business SPA300 Series, SPA500 Series, and WIP310 IP Phone Administration Guide
Number Option
87778 Restore the phone user settings to the default. (Clears all user settings
(Cisco such as speed dials.)
SPA501G)
Enter 1 to confirm, or * to exit. If you chose to reset, hang up to exit and
begin the restore process.
Reboot the phone. Enter # and hang up to begin rebooting.
732668
111 Set a static IP address. Enter the IP address (use * to enter the decimal
(.)), then press #.
To save, press 1; to review, press 2; to re-enter, press 3; to exit, press *.
NOTE
disabled, you receive an error message.
121 Set a netmask. Enter the address (use * to enter the decimal (.)), then
press #.
To save, press 1; to review, press 2; to re-enter, press 3; to exit, press *.
NOTE
disabled, you receive an error message.
131 Set a gateway. Enter the address (use * to enter the decimal (.)), then
press #.
To save, press 1; to review, press 2; to re-enter, press 3; to exit, press *.
NOTE
disabled, you receive an error message.
161 Set the address of the primary Domain Name Server (DNS). Enter the
address (use * to enter the decimal (.)), then press #.
To save, press 1; to review, press 2; to re-enter, press 3; to exit, press *.
181 Set the IP multicast address (used by the Cisco SPA 9000 to
communicate with the IP phone). Enter the address (use * to enter the
decimal (.)), then press #.
To save, press 1; to review, press 2; to re-enter, press 3; to exit, press *.
Enable or disable the web-based configuration utility. Press 1 to enable
7932
or 0 to disable, then press #.
To save, press 1; to review, press 2; to re-enter, press 3; to exit, press *.
DHCP must be disabled to use this option; if DHCP is not
DHCP must be disabled to use this option; if DHCP is not
DHCP must be disabled to use this option; if DHCP is not
1
29