Installation; Drive Belt Auto-Tensioner Removal/Installation; Tensioner Pulley Replacement - Honda Accord 2008 Manual

07/11/02 09:05:34 61TA0000_040_0034
Drive Belt Auto-tensioner Removal/

Installation

1. Remove the drive belt (see page 4-31).
2. Remove the power steering (P/S) fluid reservoir
from the holder.
3. Remove the P/S pump (A) without disconnecting
the P/S hoses, then remove the P/S hose clamp (B).
＊０１
B
4. Remove the auto-tensioner.
＊０２
8 x 1.25 mm
22 N·m
(2.2 kgf·m, 16 lbf·ft)
5. Install the auto-tensioner in the reverse order of
removal.
ＴＡ０８ＡＥ４Ａ１４１０００２２２０５ＫＤＡＴ００
6 x 1.0 mm
12 N·m (1.2 kgf·m, 8.8 lbf·ft)
10 x 1.25 mm
44 N·m (4.5 kgf·m, 33 lbf·ft)

Tensioner Pulley Replacement

1. Remove the drive belt (see page 4-31).
2. Remove the power steering (P/S) fluid reservoir
from the holder.
3. Remove the P/S pump (A) without disconnecting
the P/S hoses, then remove the P/S hose clamp (B).
B
10 x 1.25 mm
A
44 N·m (4.5 kgf·m, 33 lbf·ft)
4. Remove the auto-tensioner.
5. Clamp the auto-tensioner (A) by using two 8 mm
bolts (B) and a vise (C) as shown. Do not clamp the
auto-tensioner itself, then remove the tensioner
pulley bolt (D), then remove the tensioner pulley (E).
A
B
C
6. Install the tensioner pulley in the reverse order of
removal.
ＴＡ０８ＡＥ４Ａ１４１０００２２２０８ＫＢＡＴ０２
A
D
10 x 1.25 mm
56 N·m
(5.7 kgf·m, 41 lbf·ft)
E
4-33 4-33
＊０３
＊０４