Honda Accord 2008 Manual page 327

07/11/02 08:59:59 61TA0000_110_0008
Fuel and Emissions Systems
General Troubleshooting Information (cont'd)
12. Do the battery installation procedure (see page
22-90).
NOTE: While doing the battery installation
procedure, do not start the engine.
13. Turn the ignition switch to ON (II).
NOTE: DTC P0630 (VIN Not Programmed or
Mismatch) may be stored because the VIN has not
been programmed into the ECM/PCM; ignore it,
and continue this procedure.
14. Manually input the VIN to the ECM/PCM with the
HDS.
15. Select the IMMOBI SYSTEM with the HDS.
16. Enter the immobilizer code using the ECM/PCM
replacement procedure in the HDS; this allows you
to start the engine.
17. Update the ECM/PCM if it does not have the latest
software (see page 11-231).
18. Reset the ECM/PCM with the HDS.
19. If the TP POSITION CHECK failed in step 5, clean
the throttle body (see page 11-385).
20. Do the ECM/PCM idle learn procedure (see page
11-343).
21. Do the CKP pattern learn procedure.
11-8
OBD Status
The OBD status shows the current system status of
each DTC and all of the parameters. This function is
used to see if the repair was successfully completed.
The results of diagnostic tests for the DTC are displayed
as:
• PASSED: The on board diagnosis is successfully
finished.
• FAILED: The on board diagnosis has finished but
failed.
• EXECUTING: The vehicle is in enable criteria
conditions for the DTC and the on board diagnosis is
running.
• NOT COMPLETED: The on board diagnosis was
running but is out of the enable conditions of the DTC.
• OUT OF CONDITION: The vehicle has stayed out of
the enable conditions for the DTC.