Honda Accord 2008 Manual page 485

07/11/02 09:09:12 61TA0000_110_0166
PGM-FI System
DTC Troubleshooting (cont'd)
DTC P1298:
NOTE: Before you troubleshoot, record all freeze data
and any on-board snapshot, and review the general
troubleshooting information (see page 11-3).
1. Turn the ignition switch to ON (II).
2. Check the ELD in the DATA LIST with the HDS.
Is 0.2 A or less indicated?
YES
−
NO
time. Check for poor connections or loose terminals
at the ELD and the ECM/PCM.
3. Turn the ignition switch to LOCK (0).
4. Disconnect the ELD 3P connector.
5. Turn the ignition switch to ON (II).
6. Measure voltage between ELD 3P connector
terminal No. 1 and body ground.
＊０１
Is there battery voltage?
YES
−
NO
dash fuse/relay box. If the fuse is OK, repair open in
the wire between the No. 7 ACG (15 A) fuse and the
ELD, then go to step 12.
11-166
ELD Circuit High Voltage
− Go to step 3.
Intermittent failure, the system is OK at this
ELD 3P CONNECTOR
IG1 (BLK/RED)
Wire side of female terminals
−
Go to step 7.
Check the No. 7 ACG (15 A) fuse in the under-
7. Jump the SCS line with the HDS.
8. Disconnect ECM/PCM connector A (49P).
9. Check for continuity between ELD 3P connector
terminal No. 3 and ECM/PCM connector terminal
A24.
ELD 3P CONNECTOR
Wire side of female terminals
ECM/PCM CONNECTOR A (49P)
ELD (BLU/BLK)
Terminal side of female terminals
Is there continuity?
−
YES Go to step 10.
NO − Repair open in the wire between the ECM/
PCM (A24) and the ELD, then go to step 12.
ＴＡ０８ＡＥＡＫ７２１０００９１２９８ＦＡＡＴ３０
ELD (BLU/BLK)
＊０２