Engine Oil Replacement - Honda Accord 2008 Manual

07/11/02 09:11:20 61TA0000_080_0010
Engine Lubrication

Engine Oil Replacement

1. Warm up the engine.
2. Remove the drain bolt (A), and drain the engine oil.
＊０１
3. Reinstall the drain bolt with a new washer (B).
4. Refill the engine with the recommended oil
(see page 3-2).
Capacity
At Oil Change:
4.0 L (4.2 US qt)
At Oil Change Including Filter:
4.2 L (4.4 US qt)
After Engine Overhaul:
5.3 L (5.6 US qt)
＊０２
8-10
A
39 N·m
B
(4.0 kgf·m, 29 lbf·ft)
Replace.
Do not overtighten.
5. If the maintenance minder required engine oil
replacement, reset the maintenance minder
(see page 3-6) and this procedure is complete. If the
maintenance minder did not require engine oil
replacement, go to step 6.
6. Connect the Honda Diagnostic System (HDS) to the
data link connector (DLC) (see step 2 on page 11-3).
7. Turn the ignition switch to ON (II).
8. Make sure the HDS communicates with the vehicle
and the engine control module (ECM)/powertrain
control module (PCM). If it doesn't communicate,
troubleshoot the DLC circuit (see page 11-208).
9. Select BODY ELECTRICAL with the HDS.
10. Select ADJUSTMENT in GAUGE MENU with the
HDS.
11. Select RESET in the MAINTENANCE MINDER with
the HDS.
12. Select RESETTING THE ENGINE OIL LIFE with the
HDS.
NOTE: If you changed the automatic transmission
fluid (ATF) at the same time with the engine oil,
select RESETTING THE ENGINE OIL LIFE AND ATF
with the HDS instead.
13. Run the engine for more than 3 minutes, then check
for oil leaks.
ＴＡ０８ＡＥ４Ａ３２２０００４３７０１ＫＢＡＴ１０