Table of Contents
Advertisement
Main Menu
Engine Removal/Installation
Removal
• Make sure jacks and safety stands are placed properly
and hoist brackets are attached to the correct posi-
tions on the engine (see
• Make sure the car will not roll off stands and fall
while you are working under it.
CAUTION:
• Use a fender cover (special tool) to avoid damaging
painted surfaces.
• Unspecified items are common.
• Unplug the wiring connectors carefully while holding
the connector portion to avoid damage.
• Mark all wiring and hoses to avoid misconnection.
Also, be sure that they do not contact other wiring or
hoses or interfere with other parts.
• If the ground clearance needs to be increased, use a
scissors jack and install rubber spacers in the coil
springs (see
section
• Put rubber pads under the jacking points when using
jacks or safety stands to avoid damaging the body
(see
section
1).
1.
Move the seat bottoms and backs as far forward as
they will go.
2.
Remove the rear hatch assembly and engine cover
(see
section
20).
3.
Disconnect the battery negative terminal first, then
the positive terminal.
Table of Contents
section
1).
1).
4.
Remove the strut brace (NSX-T (open top)).
NSX FENDER COVER
07MAZ - SL0000A
Advertisement
Chapters
Table of Contents
