General Information
Exterior Parts Removal/Installation
NOTE:
When removing the front fender, do not deform its upper portion (A).
●
When reinstalling the front fender, apply the sealer all the way around the front pillar end block and the front fender
●
without gaps.
When adjusting the front door in or out, replace the mounting bolts (B); refer to the appropriate Parts Catalog for the
●
necessary adjusting bolts.
Apply spot sealer to the mating surfaces, then install the front fenders, the hood, the front doors, the tailgate, and the
●
hinges.
Check the hood, the doors, and the tailgate positions; refer to the external parts fitting positions (see page 4-15).
●
Apply sealant around the tailgate hinges (see page 5-6).
●
HOOD
HOOD HINGE
6 x 1.0 mm
18 N·m
(1.8 kgf·m,
13 lbf·ft)
FRONT PILLAR
SEALER
END BLOCK
FRONT FENDER
6 x 1.0 mm
9.3 N·m
(0.95 kgf·m, 6.9 lbf·ft)
1-10
8 x 1.25 mm
22 N·m
6 x 1.0 mm
(2.2 kgf·m, 16 lbf·ft)
18 N·m
(1.8 kgf·m, 13 lbf·ft)
6 x 1.0 mm
9.3 N·m
(0.95 kgf·m, 6.9 lbf·ft)
FRONT FENDER
8 x 1.25 mm
TAILGATE HINGE
22 N·m
(2.2 kgf·m,
16 lbf·ft)
UPPER FRONT
DOOR HINGE
(A)
LOWER FRONT
DOOR HINGE
(B)
8 x 1.25 mm
22 N·m
(2.2 kgf·m, 16 lbf·ft)
6 x 1.0 mm
9.3 N·m
(0.95 kgf·m, 6.9 lbf·ft)
6 x 1.0 mm
9.3 N·m
(0.95 kgf·m, 6.9 lbf·ft)
Right side only
6 x 1.0 mm
18 N·m
(1.8 kgf·m, 13 lbf·ft)
FUEL FILL DOOR
SLIDE DOOR
FRONT DOOR
8 x 1.25 mm
29 N·m
(3.0 kgf·m, 21 lbf·ft)
TAILGATE