Transmission End Crankshaft Oil Seal Installation - In Car - Honda Accord 2008 Manual

07/11/02 09:10:04 61TA0000_070_0035

Transmission End Crankshaft Oil Seal Installation - In Car

Special Tools Required
• Handle driver 07749-0010000
• Oil seal driver attachment 96 mm 07ZAD-PNAA100
1. Remove the transmission:
• Manual transmission (see page 13-6)
• Automatic transmission (see page 14-243)
2. M/T model: Remove the flywheel (see step 16 on
page 12-17).
3. A/T model: Remove the drive plate (see page
14-269).
4. Clean and dry the crankshaft oil seal housing.
5. Use the handle driver and the oil seal driver
attachment to drive a new crankshaft oil seal
squarely into the engine block to the specified
installed height.
＊０１
07749-0010000
07ZAD-PNAA100
6. Measure the distance between the engine block (A)
and the crankshaft oil seal (B).
Oil Seal Installed Height:
7. M/T model: Install the flywheel (see step 18 on
page 12-17).
8. A/T model: Install the drive plate (see page 14-269).
9. Install the transmission:
• Manual transmission (see page 13-16)
• Automatic transmission (see page 14-255)
ＴＡ０８ＡＥ４Ａ１８３１６６１７５１３ＫＣＡＴ００
−
0.2 1.2 mm
(0.001 0.047 in.) −
0.2 1.2 mm −
(0.001 0.047 in.) −
B
A
7-35
＊０２