Section 7: Sk, Sd And Swift™Wireless Slc Device Installation; List Of Sd Slc Devices; Swift Wireless Slc Devices; Maximum Number Of Devices - Honeywell 6808 Installation And Operation Manual

Color Guide: -IV = Ivory color, -BL = Black, -WH = White, -WHITE-White

7.2 List of SD SLC Devices

The following SD SLC devices can be used with the control panel. See the appropriate section number in this manual or the device
installation instructions (packaged with the device) for more information..
NOTE: The control panel supports the use of either SD or SK SLC devices. You cannot install both SLC device types on this control panel.
SD
Model Number
SD505-PHOTO
SD505-HEAT
SD505-6AB
SD505-6IB
SD505-6RB
SD505-6SB
SD505-DUCT
SD505-DUCTR
SD500-PS/-PSDA
SD500-AIM
SD500-MIM
SD500-ANM
SD500-ARM
SD500-SDM
SD500-LIM
SD505-DTS-K

7.3 SWIFT Wireless SLC Devices

The WSK-WGI Wireless Gateway acts as a bridge between a group of wireless fire devices and a SLC loop on
the 6808. It is powered by the SLC loop or by a regulated, external 24VDC UL-listed power supply.
Available wireless devices include a photo detector, a photo/heat detector, a fixed-temperature heat detector, a
rate-of-rise detector, and a monitor module. For updated details about wireless devices, system setup and operation see
®
the SWIFT Smart Wireless Integrated Fire Technology Manual # LS10036-001SK-E for more information.

7.4 Maximum Number of Devices

The 6808 supports SK SD or SWIFT™ SLC devices on one 6808 system. The maximum number of devices per system varies depending
on device protocol. Device support is as follows:
• SK Devices–A 6808 system can support a total of 99 SK detectors and 99 SK modules. The SLC points can be all sensors or all
modules or any combination of modules and sensors.
OR
• SD Devices–A 6808 system can support a total of 127 SD SLC detectors and modules, in any combination.
OR
• SK SWIFT Wireless Devices–A SWIFT Gateway system supports up to 50 devices: 1 SWIFT Gateway and up to 49 (in any
combination) wireless detectors and monitor modules. Multiple Gateways can be used. See the SWIFT manual P/N LS10036-
000SK-E for more information.

7.5 Wiring Requirements for SLC Devices

The following information applies to all SLC devices. Refer to the section that describes the type of device you are installing for details.
6808 Manual — P/N LS10146-001SK-E:C 09/28/2017
Table 7.1 SK SLC Devices
Model Name/Description
Photoelectric smoke detector.
Absolute temperature heat detector. Trip point range from 135°F–150°F (0°C–37°C).
6" base
6" short circuit isolator base
6" relay base
6" sounder base
Duct Smoke Detector. Duct Housing including the SD505- Analog Photoelectric
Smoke Sensor. Intake tubing for duct available in three lengths: SD505-T2 (2.5 foot);
SD505-T5 (5 foot); SD505-T10 (10 foot)
Duct Detector housing with relay base. Duct housing with relay base including
SD505- Analog Photoelectric Smoke detector pre-installed
Single or dual action addressable pull station
Addressable input module (switch input), standard size, DIP switch configurable
Mini input monitor module (switch input), small size, DIP switch configurable.
Addressable notification module
Addressable relay module DIP switch configurable.
Addressable smoke detector module.
Line isolator module. Fits in a double gang box.
Remote test switch & LED indicator for the SD505-DUCTR
Table 7.2 SD SLC Devices
SK, SD and SWIFT™Wireless SLC Device Installation
Install
Sheet PN
150955
I56-3541-00
I56-3542-00
I56-3540-00
1700-09882
1700-09882
I56-3632-00
I56-3547-00
I56-3544-00
I56-3545-00
I56-3546-00
I56-3543-00
1700-09882
75