3: Point Programming For 5880 And 5865 Modules - Honeywell 6808 Installation And Operation Manual

Programming
10. Repeat Steps 1 through 9 for all circuits.
Choices
Enter Point or Circuit
Select Type
Select Type
Select Group
Edit Name
* Only applicable for 5895XL
9.5.3 Point Programming For 5880 and 5865 Modules
To program 5880 or 5865 module points
1. Enter the installer code.
2. Select 7 for Program Menu.
3. Press 4 to enter point menu.
106
Function Selections for
Type Selections
each Type
UNUSED
NOTIF OUT NOTIF OUT
CTRL CKT CTRL CKT
CONSTANT
AUX RESET
AUX_PWR
AUX DOOR
AUX SYNC
MAN PULL
WATERFLOW
SUPERVSY
TAMPER
FIRE DRILL
SILENCE
RESET
B SWITCH*
PAS_ACK
ZN_AUX1
ZN_AUX2
SYS_AUX1
SYS_AUX2
MAN REL
ILOCK
STATUS POINT
A SWITCH* Same as B SWITCH
2-WIRE SMOKE
4-WIRE SMOKE
B DETECT*
CO 4-WIRE DET
CO 4-WIRE SUP DET
2-WIRE SMOKE
4-WIRE SMOKE
A DETECT*
CO 4-WIRE DET
CO 4-WIRE SUP DET
Table 9.3 Menu Choices for Internal/External Power Module
Comments
Constant auxiliary power.
Resettable auxiliary power.
Door holder auxiliary power.
Sounder Sync auxiliary power for System
Sensor
Refer to comments column of
Table 9.2 for description of these options
Latch or Non-latching feature only appears
for waterflow, supervisory, tamper, zone
aux1, zone aux2, system aux1, and
system aux2
Non-latching - Used to activate an ancillary
Output Group that does not active alarm,
sound PZT, display status or report events.
Reset has no affect on this point
Used for Class B, 2-wire detectors.
Used for Class B, 4-wire detectors.
Used for Class B, 4-wire CO detectors.
Latching or Non-latching used for Class B,
4-wire CO Supervisory detectors
Used for Class A, 2-wire detectors.
Used for Class A, 4-wire detectors.
Used for Class A, 4-wire CO detectors.
Latching or Non-latching used for Class A,
4-wire CO Supervisory detectors
Group or Zone selection will appear
depending on the type selected.
9.5.2
See Section
6808 Manual — P/N LS10146-001SK-E:C 09/28/2017
.