Honeywell 6808 Installation And Operation Manual page 108

Programming
6. Select Phone Line to be edited (1 or 2) by pressing the up or down arrow key, then press ENTER.

Dialing Prefix
Enter up to 9 characters to be used for such things as PBX dial-out codes, a pause, and so on. The following special characters are avail-
able:
Use the number buttons on the annunciator or the up- and down-arrow keys to select special characters. Special characters begin display-
ing after "9".
7. Enter a dialing prefix (if needed), then press ENTER. Or Press the right arrow to bypass the dialing prefix option.

Number of Answer Rings
This option is used in conjunction with HFSS Honeywell Fire Software Suite. Use this option to determine the number of rings before
the panel answers a call from the computer. Range is 00-15 rings. This option is factory-programmed as 06 rings, which should be com-
patible for most installations where the answering machine bypass feature is used. You may need to adjust it depending on the installa-
tion's telephone system.
The selection made here must match the programming for this option in the Communication Configuration dialog box of HFSS.
8. Enter the desired number of answer rings, then press ENTER.

Dial Option (TouchTone or Pulse, or TT/PL)
9. Press the up or down arrow key to select the dial option, then press ENTER.
Dial Option
PULSE
TT
TT/PL

Dial Format
10. Press the up or down arrow key to select the pulse ratio for rotary dialing option, then press ENTER.
Options are:
Dial Tone Detection Disabled

Monitor Line
Enable the line monitor for each phone line that will be used. See Figure 9.6 for location of this field on the phone lines screen. When the
phone line monitor has been enabled for a phone line, a trouble condition will occur if the line is not connected. If a phone line will not
be used, it must be disabled.
12. Select Y (monitor line) or N (don't monitor line) by pressing the up or down arrow key, then press ENTER.
108
Figure 9.6 Phone Lines Editing Screen
# Pound (or number) key on the telephone
* Star key on the telephone
, Comma (character for 2-second pause)
If this option is selected, only pulse dialing will be used for this phone line.
TouchTone dialing. If this option is selected, only TouchTone dialing will be used for this phone line.
TouchTone alternating with pulse. If this option is selected, the communicator will first attempt to use
TouchTone. It will switch to pulse if TouchTone is not successful on the first attempt. It will continue to
alternate between TT and pulse for additional attempts.
U U.S. standard format. Uses the 60 msec / 40 msec make/break ratio.
E European format. Uses the 66 msec / 34 msec make/break ratio.
11. Select Y (do disable) or N (don't disable) by pressing the up or down arrow key, then press ENTER.
Description
6808 Manual — P/N LS10146-001SK-E:C 09/28/2017