Set Up Ucr 2008 In Common Device Configuration; Set Up Ucr 2008 In Common Phone Profile - Cisco 7800 Series Administration Manual

Set Up UCR 2008 in Common Device Configuration

Table 25: UCR 2008 Parameter Location
Parameter
FIPS Mode
SSH Access
Web Access
80-bit SRTCP
IP Addressing Mode
IP Addressing Mode Preference for Signaling
Set Up UCR 2008 in Common Device Configuration
Use this procedure to set the following UCR 2008 parameters:
• IP Addressing Mode
• IP Addressing Mode Preference for Signaling
Procedure
Step 1
In Cisco Unified Communications Manager Administration, choose Device > Device Settings > Common
Device Configuration.
Step 2
Set the IP Addressing Mode parameter.
Step 3 Set the IP Addressing Mode Preference for Signaling parameter.
Step 4
Select Save.

Set Up UCR 2008 in Common Phone Profile

Use this procedure to set the following UCR 2008 parameters:
• FIPS Mode
Cisco IP Phone 7800 Series Administration Guide for Cisco Unified Communications Manager
132
Cisco IP Phone Administration
Administration Path
Device > Device Settings > Common Phone Profile
System > Enterprise Phone Configuration
Device > Phones
Device > Phone
Device > Device Settings > Common Phone Profile
Device > Phone
System > Enterprise Phone Configuration
Device > Device Settings > Common Phone Profile
Device > Device Settings > Common Phone Profile
System > Enterprise Phone Configuration
Device > Device Settings > Common Device
Configuration
Device > Device Settings > Common Device
Configuration