Cisco 7800 Series Administration Manual page 218

Control Debug Information from Cisco Unified Communications Manager
The debug information may include a single digit code that reflects the severity of the situation. Situations
are graded as follows:
• 0 - Emergency
• 1 - Alert
• 2 - Critical
• 3 - Error
• 4 - Warn
• 5 - Notification
• 6 - Information
• 7 - Debugging
Contact Cisco TAC for more information and assistance.
Procedure
Step 1 In the Cisco Unified Communications Manager Administration, select one of the following windows:
• Device > Device settings > Common Phone Profile
• System > Enterprise Phone Configuration
• Device > Phone
Step 2
Set the following parameters:
• Log Profile - values: Preset (default), Default, Telephony, SIP, UI, Network, Media, Upgrade, Accessory,
Security, Wi-Fi, VPN, Energywise, MobileRemoteAccess
Note
• Remote Log - values: Disable (default), Enable
• IPv6 Log Server or Log Server - IP address (IPv4 or IPv6 address)
Note
• The format for the IPv4 Log Server address is address:<port>@@base=<0-7>;pfs=<0-1>
• The format for the IPv6 Log Server address is [address]:<port>@@base=<0-7>;pfs=<0-1>
• Where:
• the IPv4 address is separated with dot (.)
• the IPv6 address is separated with colon (:)
Cisco IP Phone 7800 Series Administration Guide for Cisco Unified Communications Manager
204
To implement multilevel and multi-section support of the parameters, check the Log Profile
check box.
When the Log Server cannot be reached, the phone stops sending debug messages.
Cisco IP Phone Troubleshooting