Install The Cisco Ip Phone - Cisco 7800 Series Administration Manual

Install the Cisco IP Phone

Procedure
Step 1
In Cisco Unified Communications Manager Administration, click System > Cisco Unified CM.
Step 2 Click Find and select the required server.
Step 3
In Auto-registration Information, configure these fields.
• Universal Device Template
• Universal Line Template
• Starting Directory Number
• Ending Directory Number
Step 4 Uncheck the Auto-registration Disabled on this Cisco Unified Communications Manager check box.
Step 5
Click Save.
Step 6 Click Apply Config.
Related Topics
Install the Cisco IP Phone
After the phone connects to the network, the phone startup process begins, and the phone registers with
Cisco Unified Communications Manager. To finish installing the phone, configure the network settings on
the phone depending on whether you enable or disable DHCP service.
If you used autoregistration, you need to update the specific configuration information for the phone such as
associating the phone with a user, changing the button table, or directory number.
Note
Before using external devices, read
If you only have one LAN cable at your desk, you can plug your phone into the LAN with the SW port and
then connect your computer into the PC port.
You can also daisy chain two phones together. Connect the PC port of the first phone to the SW port of the
second phone.
Caution
Do not connect the SW and PC ports into the LAN.
Procedure
Step 1 Choose the power source for the phone:
Cisco IP Phone 7800 Series Administration Guide for Cisco Unified Communications Manager
36
Cisco Unified Communications Manager
Phone Addition Methods, on page 60
Documentation, on page xiii
External Devices, on page 18.
Cisco IP Phone Installation