Cisco 7800 Series Administration Manual page 197

Cisco IP Phone Troubleshooting
Table 37: Streaming Statistics area items
Item
Remote Address
Local Address
Start Time
Stream Status
Host Name
Sender Packets
Sender Octets
Sender Codec
Sender Reports Sent
(see note)
Sender Report Time Sent
(see note)
Rcvr Lost Packets
Avg Jitter
Receiver Codec
Cisco IP Phone 7800 Series Administration Guide for Cisco Unified Communications Manager
Description
IP address and UDP port of the destination of the
stream.
IP address and UPD port of the phone.
Internal time stamp indicates when Cisco Unified
Communications Manager requested that the phone
start transmitting packets.
Indication of whether streaming is active or not.
Unique, fixed name that is automatically assigned to
the phone based on the MAC address.
Total number of RTP data packets that the phone
transmitted since it started this connection. The value
is 0 if the connection is set to receive-only mode.
Total number of payload octets that the phone
transmitted in RTP data packets since it started this
connection. The value is 0 if the connection is set to
receive-only mode.
Type of audio encoding that is for the transmitted
stream.
Number of times the RTCP Sender Report has been
sent.
Internal time-stamp indication as to when the last
RTCP Sender Report was sent.
Total number of RTP data packets that have been lost
since data reception started on this connection.
Defined as the number of expected packets less the
number of packets actually received, where the
number of received packets includes any that are late
or are duplicates. The value displays as 0 if the
connection was set to send-only mode.
Estimate of mean deviation of the RTP data packet
interarrival time, measured in milliseconds. The value
displays as 0 if the connection was set to send-only
mode.
Type of audio encoding that is used for the received
stream.
Streaming Statistics
183