Configuration Utility - Honeywell Vertex M Technical Handbook

Vertex M 24-Point Continuous Monitor
TM

3.6 Configuration Utility

Before the Vertex M System can begin monitoring, you must create a configuration profile. The configuration
profile stores all of the monitor settings in a single file on the hard drive. Configuration profiles include system level
information, point settings and analyzer information. Use the Configuration menu to create a new configuration
profile or modify an existing profile.
To open the Configuration Menu, touch Main Screen, Menu and then Configuration.
Set Initial Configuration
Enter information and set parameters
common to all points and modules.
Section 3 - Startup
Configure Analyzer / Points
Defines the type of analyzer module installed in each slot.
Designates the target gas. Sets alarm levels for each point.
Define Gas Location Names
Enter the short and long names for each monitored location.
3-6