Set Up Mode; Overview; Configuration Tips; Table 4-1 Configuration Tips - Honeywell 7866 Operation And Maintenance Manual

4.1

Overview

This section describes the steps to configure the 7866 Controller/Indicator for your application.
4.2

Configuration Tips

Introduction
Table 4-1 lists some tips that will help you enter data more quickly.
Function
Displaying Groups Use the SET UP key to display the Set Up groups.
Displaying Use the FUNCTION key to display the individual parameters under each group. The prompts
are listed in the order they appear in each group.
Functions
If the SET UP key is held in, the Group prompts scroll continuously at a rate of once every 2/3
Scrolling
of a second.
Holding in either the
the forward or reverse direction while viewing Group prompts.
Changing Values When changing the value of a parameter, you can adjust a more significant digit in the upper
Quickly display by holding in one key
adjustment will move one digit to the left. Press the key again and you will move one more
digit to the left.
If you are in Set Up mode and do not press any keys for 30 seconds, the controller will time
Timing Out from
out and revert to normal operation.

Set Up Mode

Key Error When a key is pressed and the prompt "KEY ERROR" appears in the lower display, it will be
for one of the following reasons:
• Parameter is not available
• Not in Set Up mode, press SET UP key first
• Key not available for use in 7866 Controller
9/06 7866 Triple Range Digital H
4. Set Up Mode

Table 4-1 Configuration Tips

or key will increase the scroll rate to once every 1/3 of a second in
or , and pressing the other
and CO Analyzer/Indicator - Operation and Maintenance
2 2
Tip
or at the same time. The
Set Up Mode
33